Combustion Efficiency definition

Combustion Efficiency means the percentage calculated in accordance with the following formula:
Combustion Efficiency or “CE” means a Flare’s efficiency in converting the organic carbon compounds found in Combustion Zone Gas to carbon dioxide. Combustion Efficiency must be determined in accordance with Appendix 1.2.
Combustion Efficiency of a space heater” means a measure of the percentage of heat from the combustion of gas or oil that is transferred to the space being heated or lost as jacket loss, as determined using the applicable test method in section 1604(e) of this Article.

Examples of Combustion Efficiency in a sentence

  • Appliance conforms to IS 813:20020; and (bb) Boiler Combustion Efficiency Test Results.

  • Boiler Combustion Efficiency shall be tested annually and results reported on annually as part of the AER.

  • To demonstrate continuous compliance with the 98% Combustion Efficiency, the Defendants must operate each Covered Flare in compliance with the applicable requirements in Paragraph 43.

  • By no later than the Effective Date, the Defendants must operate each Covered Flare with a minimum of a 98% Combustion Efficiency at all times when Waste Gas is vented to it.

  • Maintenance Combustion Efficiency Test + Inspect, Clean & Adjust Belt(s) CAD Cell Eye Chimney Base Electrodes Fan/Limit Control Filters Fuel Pump Strainer Heat Exchanger Lubrication Nozzle (replace as necessary) Oil Filter (replace) Oil Line (vacuum test) Oil Line Fittings Oil Tank OSV Valve Pump Pressure Flue Pipe Solenoid Valve Stack Relay Temperature Rise Thermostat Tube/End Cone Vacuum Level 1 (if needed)* *Level 1 Vacuum is the removal of normal soot from the unit.

  • Combustion Efficiency Air to Fuel RatioExcess Air Boiler EconomizersSteam Traps Steam LeaksCondensate Return Boiler BlowdownWaste Heat Recovery Flash SteamScaling and Fouling TurbulatorsHHV and LHV Condensing Boilers REF: Mehta and Thumann, Handbook of Energy Engineering, Chapter 6.

  • Combustion Efficiency Air to Fuel RatioExcess Air Boiler EconomizersSteam Traps Steam Leaks Condensate Return Boiler BlowdownWaste Heat Recovery Flash SteamScaling and Fouling TurbulatorsHHV and LHV Condensing Boilers REF: Mehta and Thumann, Handbook of Energy Engineering, Chapter 6.

  • Boiler Combustion Efficiency shall be tested annually and results reported as part of the AER.

  • Settling Defendants shall implement the following Interim Combustion Efficiency Measures at each Covered Flare as set forth in Appendix C - 2.1 until such Covered Flare complies with the requirements of Paragraph 139.

  • Nevertheless, there have been some sizable projects undertaken with State agencies.


More Definitions of Combustion Efficiency

Combustion Efficiency or “CE” means a Flare’s efficiency in converting the organic carbon compounds found in Combustion Zone Gas to carbon dioxide. Combustion Efficiency must be determined as set forth in the equation on page 2 of Appendix 1.2.
Combustion Efficiency or “CE” shall mean a Flare’s efficiency in converting the organic carbon compounds found in Vent Gas to carbon dioxide. Combustion
Combustion Efficiency or “CE” shall mean a Flare’s efficiency in converting the organic carbon compounds found in Vent Gas to carbon dioxide. Combustion Efficiency shall be calculated as set forth in Equation 1 in Appendix C - 1.2 of this Consent Decree.
Combustion Efficiency or “CE” means a Covered Flare’s efficiency in converting the organic carbon compounds found in Combustion Zone Gas to carbon dioxide.
Combustion Efficiency. , etacomb , means the efficiency taking into account only heat loss in flue gases;
Combustion Efficiency or “CE” shall mean a Flare’s efficiency in converting the organic carbon compounds in a Vent Stream to carbon dioxide.

Related to Combustion Efficiency

  • Irrigation efficiency (IE) means the measurement of the amount of water beneficially used divided by the amount of water applied. Irrigation efficiency is derived from measurements and estimates of irrigation system characteristics and management practices. The irrigation efficiency for purposes of this ordinance are 0.75 for overhead spray devices and 0.81 for drip systems.

  • Thermal efficiency means the useful electric energy output of a

  • Energy efficiency means the ratio of output of performance, service, goods or energy, to input of energy;

  • high-efficiency cogeneration means cogeneration meeting the criteria laid down in Annex II;

  • Combustion turbine means an enclosed fossil or other fuel-fired device that is comprised of a compressor, a combustor, and a turbine, and in which the flue gas resulting from the combustion of fuel in the combustor passes through the turbine, rotating the turbine.

  • Capture efficiency means the weight per unit time of VOC entering a capture system and delivered to a control device divided by the weight per unit time of total VOC generated by a source of VOC, expressed as a percentage.

  • Co-generation means the sequential production of electricity

  • Turbidity means the cloudy condition of water due to the presence of extremely fine particulate materials in suspension that interfere with the passage of light.

  • Internal combustion engine or ‘engine’ means an energy converter, other than a gas turbine, designed to transform chemical energy (input) into mechanical energy (output) with an internal combustion process; it includes, where they have been installed, the emission control system and the communication interface (hardware and messages) between the engine's electronic control unit(s) and any other powertrain or non-road mobile machinery control unit necessary to comply with Chapters II and III;

  • Transfer efficiency means the ratio of the weight of coating solids adhering to the object being coated to the weight of coating solids used in the application process, expressed as a percentage.

  • Gasification means the substoichiometric oxidation or steam reformation of a substance to produce a gaseous mixture containing two or more of the following: (i) oxides of carbon; (ii) methane; and (iii) hydrogen;

  • Energy efficiency measure means equipment, devices, or materials intended to decrease energy consumption, including, but not limited to, upgrades to a building envelope such as insulation and glazing; improvements in heating, ventilating and cooling systems; automated energy control systems; improved lighting, including daylighting; energy‑recovery systems; combined heat and power systems; or another utility cost‑savings measure approved by the governing body.

  • Energy efficiency improvement means equipment, devices, or materials intended to decrease energy consumption, including, but not limited to, all of the following:

  • Stationary internal combustion engine means a spark or compression ignited, reciprocating internal combustion engine that is not a portable emission unit.

  • cogeneration means the simultaneous generation in one process of thermal energy and electrical or mechanical energy;

  • Efficiency means the gas turbine manufacturer's rated heat rate at peak load in terms of heat input per unit of power output based on the lower heating value of the fuel.

  • Electric utility steam generating unit means any steam electric generating unit that is constructed for the purpose of supplying more than one-third of its potential electric output capacity and more than 25 MW electrical output to any utility power distribution system for sale. Any steam supplied to a steam distribution system for the purpose of providing steam to a steam-electric generator that would produce electrical energy for sale is also considered in determining the electrical energy output capacity of the affected facility.

  • Sewage sludge weight means the weight of sewage sludge, in dry U.S. tons, including admixtures such as liming materials or bulking agents. Monitoring frequencies for sewage sludge parameters are based on the reported sludge weight generated in a calendar year (use the most recent calendar year data when the NPDES permit is up for renewal).

  • Working voltage means the highest value of an electrical circuit voltage root-mean-square (rms), specified by the manufacturer, which may occur between any conductive parts in open circuit conditions or under normal operating conditions. If the electrical circuit is divided by galvanic isolation, the working voltage is defined for each divided circuit, respectively.

  • Wastewater treatment plant means a facility designed and constructed to receive, treat, or store waterborne or liquid wastes.

  • Electric power generator means an entity that proposes to